This command is only valid for the datasource key “X240”, “X500”, “X500e” or “X700” This command is an optional command to allow for specifying the channel mask for LE Direct Test Mode Channel Selection to be included in analyze. The parameter value must be specified as a hex value with a leading “0x” The parameter value must not exceed 5 bytes (40 bits) in size. The command format is:
“letestmodechannelfilter= <hex value>”
Example – “letestmodechannelfilter=0xC3”
“CONFIG SETTINGS; IOParameters;X500;letestmodechannelfilter=0xC3”
The above example command will result in LE Direct Test Mode packets being filtered in for channels 0, 1, 6, & 7.