The Start FTS command is used to start a personality for live capture. The analyzer can only start one personality at a time. If the analyzer has already started a personality, or a capture file is open, a FAILED response will be returned. A SUCCEEDED response is returned if the personality has been successfully started.
Failure to start the personality will result in a FAILED notification response from the server. The failure notification response may or may not be accompanied by a reason parameter.
Command format: “Start FTS;<fts.exe directory>;<personality key>”
|
Parameter |
Description |
|
fts.exe directory |
The directory that contains the instance of fts.exe to launch. This parameter must refer to a valid directory or be “none” to launch the fts.exe instance that is co-located with the running Automation Server. |
|
personality key |
Key to the personality used to form the fts.exe command line where valid values are presented in the table below. |
For configurations that include one or more X240 devices, the capture technology should be configured by using the appropriate datasource prior to starting capture via automation. Configuration of capture technology and initiating firmware update are not supported via the automation interface.
Response: “START FTS;<status>[;Reason= <reason>]”