The Stop Analyze command is sent to the datasource. This command does not require capture hardware to be connected if a capture file is open. The command format is:
“Stop Analyze”
It should be noted that Sodera, X240, X500, X500e and X700 have the capacity to buffer frames for processing and it might take some time to fully process those buffers. To ensure all captured frames are processed, the sequence of commands recommended to stop capture and processing of data would be:
-
Stop Record
-
Is Analyze Complete – Repeat until status indicating completion has been received (see Is Analyze Complete).
-
Stop Analyze
Response: “STOP ANALYZE;<status>[;Reason=<reason>]” where a reason will only be supplied for FAILED status.