The Get Capture State command is sent to the datasource to get the capture state of the Sodera, X240, X500, X500e or X700. This command does not require capture hardware to be connected. The command format is:
“Get Capture State”
Response: “GET CAPTURE STATE;<status>;Reason=<reason>” where reason will be supplied for SUCCEEDED and FAILED status.
For SUCCEEDED status, reason will be “<capture state> where capture state can be
-
Capture Stopped – Capture has stopped.
-
Capture Stopping – Capture is stopping.
-
Capture Starting – Capture is starting.
-
Capture Active – Capture is active.
-
Invalid Capture State – Invalid capture state.