The Configure BD_ADDRs command is sent to the datasource to pre-select BD_ADDR values for the analyze operation of the Sodera, X240, X500, X500e or X700. This command does not require capture hardware to be connected. The command format is:
“Configure BD_ADDRs;<address list>”
Address list is a comma-delimited string of BD_ADDRs to be selected for analyze. Example – “Configure BD_ADDRs;0x001122334455,0xaabbccddeeff”
Response: “CONFIGURE BD_ADDRs;<status>;Reason=<reason>” where reason will be supplied for SUCCEEDED and FAILED status.
For SUCCEEDED status, reason will be “<status>” where status may be
-
“addresses_configured=none” – The supplied address list was empty, and nothing was configured or there was a command processing error.
-
“addresses_configured=some|<BD_ADDR>|<BD_ADDR>|…|<BD_ADDR>|configuration_err or=No device found for addresses|<BD_ADDR>|<BD_ADDR>|…|<BD_ADDR>” - Some addresses were configured and others were not.
-
“addresses_configured=all||<BD_ADDR>|<BD_ADDR>|…|<BD_ADDR>” – All addresses were successfully configured.