This command is sent to the datasource application to initialize the IO settings for a capture device:
-
The parameters will be parsed for correctness.
-
The client can begin capturing or sniffing without setting the IO. The analyzer will use the previously configured values from the datasource INI file or the system defaulted values.
-
Valid IO settings are dependent upon the devices being tested.
-
For any configuration that you send, you must have a data source key that matches the type of I/O settings in the application.
-
Some devices do not support Extension channels or 5 GHz channels. The configuration will fail if the settings are not supported by the device.
-
Currently logic signal settings cannot be directly configured with the automation server.
Review the section “Configuring Logic Signals” before performing a capture.
Valid DataSource Keys are:
-
Sodera
-
X240
-
X500
-
X500e
-
X700
The config settings command format for DataSource Keys “Sodera”, “X240”, “X500”, “X500e” and “X700” for all Personality Keys except “DoubleX240” and “TripleX240” is:
“Config Settings;IOParameters;<datasource key>;<config settings>”
The config settings command format for DataSource Key “X240” using Personality Key “DoubleX240” and “TripleX240” is:
“Config Settings;IOParameters;<datasource key>;<serial number key>;<config settings>”
Serial number key is in the form of “serial_number=serial number” where the serial number value is serial number of the X240 connected to the target datasource.
Response: “CONFIG SETTINGS;<status>[;Reason=<reason>]” where a reason will only be supplied for FAILED status.