v10.50 v10.55 Alpha v10.54 Alpha v10.53 Alpha v10.52 Alpha v10.51 Alpha
v10.50 v10.55 Alpha v10.54 Alpha v10.53 Alpha v10.52 Alpha v10.51 Alpha
Breadcrumbs

Setting Up the Analyzer: USB Connection

To set up an analyzer using a USB connection:

1. Connect the USB port on the analyzer to a USB port on the host machine using the LONG (6-foot/2-meter) USB 2.0 cable or 1-meter 3.2 cable.

  1. Download and install the most current software for your analyzer from https://teledynelecroy.com/sw/usb/ (required USB driver files are included with the software).

  2. Power on the analyzer.

NOTE: At power-on, the analyzer initializes itself in approximately ten seconds and performs a self-diagnostic that can last a few minutes. If the diagnostics fail, contact Teledyne LeCroy Customer Support for assistance.

  1. When Add New Hardware Wizard opens on the host machine, click Next.

  2. Follow the on-screen instructions for automatic installation of the analyzer as a USB device on your host machine.

  3. Click Finish when you see the message that says Windows has finished installing the software that your new hardware requires and the driver files have been installed in your host machine.

  4. Check analyzer setup in the “Application Startup” section (See Application Startup).

WARNING: Do not change from USB to Ethernet, or back, without power cycling the analyzer.

NOTE: Disconnection of USB or Ethernet during capture or uploading of trace data is not supported, and could cause the software to malfunction.