Before you can install and use the USB Compliance Suite software, you must install the USB Protocol Suite software. The steps below apply to the installation of both the USB Protocol Suite software and the USB Compliance Suite software. Consult the USB Protocol Suite User Manual for detailed instructions.
NOTE: The USB Compliance Suite software will not run without the USB Protocol Suite software.
Install the USB Protocol Suite software
-
Download the latest software to your computer from the website: https://teledynelecroy.com/sw/usb/
-
Double-click on the executable file to launch the installer.
-
Follow the on-screen instructions to complete the installation.
-
Click Next to complete the installation.
USB Driver Installation
USB driver files are automatically installed with the USB Protocol Suite software installation. You must have administrator privileges to install the required device drivers.
Do not connect the analyzer to the USB port until the software installation is complete. Reference the USB Protocol Suite User Manual if you run into any problems installing that software.