Updates and Bug Fixes

USB Compliance Suite v8.32 build 1241 (December 1, 2025)

Requires USB Protocol Suite v10.12 or later

Test updates and improvements

  • USBCOMP-23342: [DPAM] Implement v2.1a CTS (draft September_24_2025)

  • USBCOMP-23395: [VIF Editor] DPAM section will always been shown if it’s present in VIF

  • USBCOMP-23431: [Cable Orientation] Continue when BOS descriptor cannot be extracted

  • USBCOMP-23446: Change "Indeterminate" result to "Incomplete"

  • USBCOMP-23447: Show "Incomplete" instead of N/A when test cannot be run

  • USBCOMP-23538: Added support for Voyager M480x

Bug fixes

  • USBCOMP-23258: [TEST.PD.PS.SRC.1] SPR AVS: Tester requests bad current

  • USBCOMP-23300: [TEST.PD.PROT.SRC3.10#5] False failure when UUT sends PS_RDY

  • USBCOMP-23324: [COMMON.PROC.PD.18] False failure due to incorrect Operating Current value

  • USBCOMP-23382: [TEST.PD.PS.SNK.1#10]

  • USBCOMP-23394: [TD.DP.10.4.3] Cable test scenario aborted due to missing Vconn

  • USBCOMP-23397: [TD 4.2.1 V.2] False failure

  • USBCOMP-23398: [User Manual] Online manual could not be opened

  • USBCOMP-23421: [TD 4.10.3] Failure based on suspend current

  • USBCOMP-23427: [TEST.PD.FRS.SNK3.1] VIF parse error on EPR condition

  • USBCOMP-23432: [TD 4.9.5 V.8] Improved Unattached verification

  • USBCOMP-23433: [TD.4.10.2] Test scenario aborted

  • USBCOMP-23435: [TEST.PD.PS.SNK.3] PDO verification offset

  • USBCOMP-23437: [TEST.PD.EPR.SNK3.12] COMMON.CHECK and .PROC false failures

  • USBCOMP-23441: [TD.4.2.2 V.1] False failure in Rp verification

  • USBCOMP-23442: [COMMON.CHECK.PD.2] MessageID check incorrectly compares SOP and SOP' messages

  • USBCOMP-23443: [TEST.PD.PS.SNK.1] Unknown failure

  • USBCOMP-23444: [TEST.PD.PS.SRC.1#4] Slew rate measurement issue

  • USBCOMP-23445: [TD.4.13.2] USB2 Exerciser does not send 10 ms reset

  • USBCOMP-23449: [TEST.PD.FRS.SNK3.1#8, #3] Verification issue

  • USBCOMP-23450: [TEST.PD.PROT.SRC3.14#1] SIDO2 B17:9, B8:0 decoding issue

  • USBCOMP-23451: [TD 4.10.6] Automation failure - Unable to open TD.4.10.6_Host.UTG

  • USBCOMP-23455: [TEST.PD.PS.SRC.1#9, #10, #11, #13, #2] SPR AVS APDO

  • USBCOMP-23457: [TD 4.5.2] Rd terminations timing

  • USBCOMP-23480: [TEST.PD.PS.SNK.1] pSnkSusp timing and measurement

  • USBCOMP-23487: [TEST.PD.PS.SNK.3#5, #12, #13] Invalid Requests

  • USBCOMP-23488: [TD 4.7.5 V.1] PUT not sourcing Vconn

  • USBCOMP-23490: [TD 4.4.4 V.4, V.5] Improved state detection

  • USBCOMP-23492: [TD 4.2.1 V.2] PUT not sourcing Vconn

  • USBCOMP-23493: [TEST.PD.PROT.SNK3.5#1] Measurement performed incorrectly

  • USBCOMP-23501: [TD.DP.10.3.5] Corrected marker locations

  • USBCOMP-23504: [TEST.PD.PS.SRC.2] Tester starts with bad request