Breadcrumbs

Updates and Bug Fixes

USB Compliance Suite v8.30 build 1238 (October 10, 2025)

Requires USB Protocol Suite v10.12 or later

Test updates and improvements

  • USBCOMP-23098: [TEST.PD.PS.SNK.3#12] Indeterminate - True failure, but improve error message

  • USBCOMP-23194: [TEST.PD.PS.SRC.5#3 - #5 and #10 - #11]

  • USBCOMP-23216: [TEST.PD.PS.SNK.3#12] Indeterminate - True failure, but improve error message

  • USBCOMP-23306: [VIF] Add support for VIF v3.36

  • USBCOMP-23217: [Installation] Transitioned to new installer framework

Bug fixes

  • USBCOMP-23154: [TEST.PD.USB4.DRST.1] Remove #6 from report

  • USBCOMP-23170: [TEST.PD.PS.SRC.3#1] Indeterminate with NAK response for Discover Identity

  • USBCOMP-23187: [TEST.PD.PROT.ALL.4] False Failure – Vbus restored after Hard Reset

  • USBCOMP-23197: [COMMON.PROC.PD.6] Rev 2 timing failure

  • USBCOMP-23198: [COMMON.PROC.PD.18] Should not be run (Has_Invariant_PDOs set to N and current Source Caps match)

  • USBCOMP-23245: [TEST.PD.PROT.SRC.3.8#2]

  • USBCOMP-23261: [TEST.PD.PROT.SRC3.4#1] No response to Alert

  • USBCOMP-23297: [TEST.PD.PS.SRC.1] Bad PPS Request

  • USBCOMP-23307: [TEST.PD.PS.SRC.1#8] Indeterminate

  • USBCOMP-23308: [TEST.PD.PS.SRC.1#9, #10, #11, #13, #2]

  • USBCOMP-23309: [TEST.PD.PS.SRC.3]

  • USBCOMP-23313: [TD 6.2] "Bad Function Call" error

  • USBCOMP-23314: [TEST.PD.PROT.SRC.4] False failure for COMMON.PROC.PD.18

  • USBCOMP-23317: [TEST.PD.PS.SRC.1#2]

  • USBCOMP-23320: [TEST.PD.PS.SRC.1#10]

  • USBCOMP-23321: [TEST.PD.EPR.SNK3.12] Run despite N/A

  • USBCOMP-23322: [TEST.PD.PROT.SRC3.14#1]

  • USBCOMP-23323: [TEST.PD.PROT.SRC.8#2]

  • USBCOMP-23324: [COMMON.PROC.PD.18] False failure due to incorrect Operating Current value

  • USBCOMP-23326: [TEST.PD.EPR.SNK3.12#2] Indeterminate

  • USBCOMP-23334: [TEST.PD.EPR.SNK3.12#6]

  • USBCOMP-23336: [TEST.PD.PROT.SNK.10 Rev2Snk]

  • USBCOMP-23337: [COMMON.PROC.BU.5] False failure on TEST.PD.PROT.SNK3.5

  • USBCOMP-23339: [TEST.PD.PS.SRC.1] False failures

  • USBCOMP-23361: [TEST.PD.PROT.SNK3.2] No failure conditions

  • USBCOMP-23364: [TEST.PD.PROT.SNK.12#2] Should be N/A if UUT is Consumer Only

  • USBCOMP-23363: [TEST.PD.PROT.SRC3.4]

  • USBCOMP-23365: [TEST.PD.EPR.SNK3.12] Indeterminate - Automation Failure

  • USBCOMP-23366: [TEST.PD.EPR.SRC3.15#5] False failure

  • USBCOMP-23367: [TEST.PD.PROT.SNK.13] Fails after test should stop

  • USBCOMP-23368: [TEST.PD.PS.SNK.1]

  • USBCOMP-23369: [Common Check Results] Minor typo

  • USBCOMP-23371: [TD 4.9.5] False Vconn detection

  • USBCOMP-23372: [TEST.PD.EPR.SNK3.12] Test was allowed to run without power supply