-
Users may be prompted twice to update firmware. Follow both prompts to complete the update successfully.
-
Users working with custom methods related to adding vendor specific commands should reach out to the technical support team to get help on upgrading custom methods to match WPS 3.00 and later releases.
-
When capturing in the Continuous Capture mode using the Analyze All Sessions option, spectrum data (if configured) will only be displayed for the current session.
-
After adding new bookmarks to an existing file, the application does not prompt to save changes. To mitigate this issue, save the capture explicitly using Save As under the File menu.
-
The following issues are specific to X700, and a fix is planned for post-release maintenance update.
-
Audio gaps may be observed when retransmitted packets and subsequent packets drop cause buffer underruns during stream reconstruction in Audio Expert System.
-
Reduced packet capture performance may be observed for LE 2M and Long Range PHY traffic at signal levels below -80 dBm.
-
Support for Autoboot functionality is planned for a subsequent release.
-
The following issues are specific to Wireless Protocol Suite on macOS and Linux.
-
BT Snoop Overlay shall be supported in a future release.
-
Custom decoder filesets are applied directly via installers (.pkg and .deb) when Wireless Protocol Suite is not running. Wi-Fi decryption is still applied via the Install Fileset option under the File menu.
-
Only a single instance of Wireless Protocol Suite can run concurrently on macOS and Linux.
-
Ensure Energy Saver mode (applicable only to macOS) is turned off on the host machine, otherwise the hardware may disconnect from the system during sleep mode or periods of inactivity.