Automation API Manual

This manual describes the USB Protocol Suite Automation, an Application Program Interface (API) that allows users to create scripts or programs of commands and run these scripts or programs locally or remotely over a network. Topics covered:

• Introduction

• Primary Dual Interface for Analyzer

• Primary Dual Interface for Trace

• Primary Dual Interface for Packet

• Primary Dual Interface for USB Verification Script Engine

• Primary Dual Interface for Recording Options

• Verification Script Engine Events Callback Interface

• Errors Collection Interface

• Analyzer Events Callback Interface

• CATCAnalyzerAdapter

• DCOM Configuration

Document Disclaimer

The information contained in this document has been carefully checked and is believed to be reliable. However, no responsibility can be assumed for inaccuracies that might not have been detected.

Teledyne LeCroy reserves the right to revise the information presented in this document without notice or penalty.

Trademarks and Servicemarks

CATC Trace, Mercury, Advisor, and Voyager are trademarks of Teledyne LeCroy

Microsoft and Windows are registered trademarks of Microsoft Inc.

All other trademarks are property of their respective companies.

Copyright

Copyright © 2002 Teledyne LeCroy, Inc. All Rights Reserved.

This document may be printed and reproduced without additional permission, but all copies should contain this copyright notice.

Contact Teledyne LeCroy